Which protocol does an access point use to draw power from a connected switch? A. Internet Group Management Protocol B. Cisco Discovery Protocol C. Adaptive Wireless Path Protocol D. Neighbor Discovery Protocol. An engineer needs to add an old switch back into a network. To prevent the switch from corrupting the VLAN database, with action must be taken? A. Add the switch in the VTP domain with a lower revision number. B. Add the switch in the VTP domain with a higher revision number. C. Add the switch with DTP set to dynamic desirable. D. Add the switch with DTP set to desirable. An engineer must configure traffic for a VLAN that is untagged by the switch as it crosses a trunk link. Which command should be used? A. switchport trunk encapsulation dot1q B. switchport trunk allowed vlan 10 C. switchport mode trunk D. switchport trunk native vlan 10. Refer to the exhibit. A network engineer is in the process of establishing IP connectivity between two sites. Routers R1 and R2 are partially configured with IP addressing. Both routers have the ability to access devices on their respective LANs. Which command set configures the IP connectivity between devices located on both LANs in each site? A. R1 ip route 192.168.1.1 255.255.255.0 GigabitEthernet0/1 R2 ip route 10.1.1.1 255.255.255.0 GigabitEthernet0/1 B. R1 ip route 192.168.1.0 255.255.255.0 GigabitEthernet0/0 R2 ip route 10.1.1.1 255.255.255.0 GigabitEthernet0/0 C. R1 ip route 0.0.0.0 0.0.0.0 209.165.200.225 R2 ip route 0.0.0.0 0.0.0.0 209.165.200.226 D. R1 ip route 0.0.0.0 0.0.0.0 209.165.200.226 R2 ip route 0.0.0.0 0.0.0.0 209.165.200.225. Refer to the exhibit. Which configuration for RTR-1 denies SSH access from PC-1 to any RTR-1 interface and allows all other traffic? a b.