Refer to the exhibit. Which Command do you enter so that R1 advertises the loopback0 interface to the BGP Peers?
A. Network 172.16.1.32 mask 255.255.255.224 B. Network 172.16.1.0 0.0.0.255 C. Network 172.16.1.32 255.255.255.224 D. Network 172.16.1.33 mask 255.255.255.224 E. Network 172.16.1.32 mask 0.0.0.31 F. Network 172.16.1.32 0.0.0.31. Which command should you enter to verify the priority of a router in an HSRP group? show hsrp show sessions show interfaces show standby. Refer to the exhibit. What action establishes the OSPF neighbor relationship without forming an adjacency?
A. modify priority B. modify process ID C. modify hello interval D. modity network type. Refer to Exhibit. An engineer is configuring the NEW York router to reach the Lot interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two) A. ipv6 router 2000::1/128 2012::1 B. ipv6 router 2000::1/128 2012:1 5 C. ipv6 router 2000::1/128 2012::2 D. ipv6 router 2000::1/128 2023:2 5 E. ipv6 router 2000::1/128 2023::3 5. Refer to the exhibit. An engineer is bringing up a new circuit to the MPLS provider on the Gi0/1 interface of Router1.
The new circuit uses eBGP and teams the route to VLAN25 from the BGP path. What is the expected behavior for the traffic flow for route 10.10.13.0/25? A. Traffic to 10.10.13.0.25 is load balanced out of multiple interfaces B. Route 10.10.13.0/25 is updated in the routing table as being learned from interface Gi0/1. C. Traffic to 10.10.13.0/25 is a symmetrical D. Route 10.10.13.0/25 learned via the Gi0/0 interface remains in the routing table. Refer to the exhibit. The show ip ospf interface command has been executed on R1. How is OSPF configured? A. A point-to-point network type is configured. B. The interface is not participating in OSPF. C. The default Hello and Dead timers are in use. D. There are six OSPF neighbors on this interface. Refer to the exhibit. Which route type is configured to reach the Internet? A. floating static route B. host route C. network route D. default route. Refer to the exhibit. After the configuration is applied, the two routers fail to establish an OSPF neighbor relationship. What is the reason for the problem?
A. The OSPF process IDs are mismatched B. The network statement on Router1 is misconfigured C. Router2 is using the default hello timer D. The OSPF router IDs are mismatched. Refer to the exhibit. After the configuration is applied, the two routers fail to establish an OSPF neighbor relationship. What is the reason for the problem? A. The OSPF process IDs are mismatched B. The network statement on Router1 is misconfigured C. Router2 is using the default hello timer D. The OSPF router IDs are mismatched .
