ERASED TEST, YOU MAY BE INTERESTED ON Aruba Campus Access Professional - part 2
COMMENTS |
STATISTICS |
RECORDS
|
|---|
TAKE THE TEST
|
Title of test:
Aruba Campus Access Professional - part 2 Description: Aruba Campus Access Author:
Creation Date: 20/11/2024 Category: Others Number of questions: 21 |
Share the Test:
New Comment
No comments about this test.
Content:
|
A network engineer recently identified that a wired device connected to a CX Switch is
misbehaving on the network To address this issue, a new ClearPass policy has been put in place to
prevent this device from connecting to the network again.
Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for
this wired device? (Select two.) A. Confirm that NTP is configured on the switch and ClearPass
B. Configure dynamic authorization on the switch.
C. Bounce the switchport
D. Use Dynamic Segmentation.
E. Configure dynamic authorization on the switchport
. Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection) A. Use the UXI app on your smartphone and connect the UXI via Bluetooth B. Use the Aruba installer app on your smartphone to scan the barcode C. Connect the new UXI from an already installed one and adjust the initial configuration. D. Use the CLI via the serial cable and adjust the initial configuration. . Your customer is complaining of weak Wi-Fi coverage in their office. They mention that the office on the other side of the hall has much better signal What is the likely cause of this issue? A. The AP is a remote access point. B. The AP is using a directional antenna. C. The AP is an outdoor access point. D. The AP is configured in Mesh mode . You are troubleshooting an issue with a 10 102.39 0/24 subnet which is also VLAN 1000 used Tor wireless clients on a pair of Aruba CX 8360 switches The subnet SVI is configured on the 8360 pair, and the DHCP server is a Microsoft Windows Server 2022 Standard with an IP address of 10 200 1.100. The 10.102.250.0/24 subnet is used for switch management. A large number of DHCP requests are failing You are observing sporadic DHCP behavior across clients attached to the CX 6100 switch. Which action may help fix the issue? A. Enter the following commands on the VSX primary switch: vsx vsx-sync dhcp-relay exit B. Enter the following commands on the VSX secondary switch: vlan 1000 ip relay-address 10.200.1.100 exit C. Add an SVI in the 10.102.39.0/24 subnet on the Aruba CX 6100 switch that the APs are connected to D. Enter the following command on the Aruba CX 6100 switch: interface vlan 1000 ip helper-address 10.200.1.100 exit. Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot? A. Hybrid Mode B. Air Monitor C. Spectrum Monitor D. Dual Mode . Due to a shipping error, five (5) Aruba AP-515S and one (1) Aruba CX 6300 were sent directly to your new branch office You have configured a new group persona for the new branch office devices in Central, but you do not know their MAC addresses or serial numbers The office manager is instructed via text message on their smartphone to onboard all the new hardware into Aruba Central What application must the office manager use on their phone to complete this task? A. Aruba Onboard App B. Aruba Central App C. Aruba CX Mobile App D. Aruba installer App . Your customer has asked you to assign a switch management role for a new user The customer requires the user role to View switch configuration information and have access to the PUT and POST meth0ds for REST API. Which default AOS-CX user role meets these requirements? A. administrators B. auditors C. sysops D. helpdesk . What is the best practice for handling voice traffic with dynamic segmentation on AOS-CX switches? A. Switch authentication and local forwarding of the voice traffic B. Switch authentication and user-based tunneling of the voice traffic. C. Central authentication and port-based tunneling of the voice traffic. D. Controller authentication and port-based tunneling of all traffic . A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. The legacy devices are connected to Aruba CX 6300 switches throughout the campus. Which technology minimizes flooding so the legacy application can work efficiently? A. Generic Routing Encapsulation (GRE) B. EVPN-VXLAN C. Ethernet over IP (EolP) D. Static VXLAN . What is the order of operations tor Key Management service for a wireless client roaming from AP1 to AP2? Cache the clients information Client associates and authenticates to AP1 Generate Pairwise Master Key keys for AP1's neighbors Get AP1 neighbor AP list Share Pairwise Master Key along with VLAN and User Role to target APs. You are troubleshooting an issue with a pair of Aruba CX 8360 switches configured with VSX Each switch has multiple VRFs. You need to find the IP address of a particular client device with a known MAC address You run the "show arp" command on the primary switch in the pair but do not find a matching entry for the client MAC address. The client device is connected to an Aruba CX 6100 switch by VSX LAG. Which action can be used to find the IP address successfully? A. Run the following command on the CX 6100 switch: show mac-address-table B. Run the following command on the VSX primary switch: show arp all-vrfs C. Run the following command on the VSX primary switch: show mac-address-table D. Run the following command on the CX 6100 switch: show arp all-vrfs. You must ensure the HPEAruba network you are configuring for a client is capable of plug-and-play provisioning of access points. What enables this capability? A. UCC Service B. LLDP-MED C. SRTP D. CSMA . You are configuring an SVI on an Aruba CX switch that needs to have the following characteristics: * VLANID = 25 . IPv4 address 10 105 43 1 with mask 255 255 255.0 * IPv6 address fd00:5708::f02d:4df6 with a 64 bit prefix length * member of VRF eng * VRF eng and VLAN 25 have not yet been created Which command lists will satisfy the requirements with the least number of commands? A. vrf eng vlan 25 interface vlan 25 ip address 10.105.43.1 255.255.255.0 ipv6 address fd00:5708::f02d:4df6/64 vrf attach eng B. interface vlan 25 vrf attach eng ip address 10.105.43.1/24 ipv6 address fd00:5708::f02d:4df6/64 C. interface vlan 25 vrf attach eng ip address 10.105.43.1/24 ipv6 address fd00:5708::f02d:4df6/64 D. vrf eng vlan 25 interface vlan 25 ip address 10.105.43.1/24 ipv6 address fd00:5708::f02d:4df6/64 vrf attach eng. You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new default route to 10.1.1.253. Other non-default routes for this subnet should not be affected by this change. What are two parts of the solution for these requirements? (Select two.) A. pbr-action-list def_route_test default-nexthop 10.1.1.253/24 B. class ip test_subnet 10 match any 10.2.250.0/24 any policy def_route_test_policy 10 class ip test_subnet action pbr def_route_test interface vlan 100 ip address 10.2.250.0/24 apply policy pbr_test routed in C. class ip test_subnet 10 match any 10.2.250.0 255.255.255.0 any policy def_route_test_policy 10 class ip ip_test_subnet action pbr def_route_test interface vlan 100 ip address 10.2.250.0/24 apply policy pbr_test routed out D. pbr-action-list def_route_test default-nexthop 10.1.1.253 interface null E. pbr-action-list def_route_test nexthop 10.1.1.253 interface null. Match the terms below to their characteristics (Options may be used more than once or not at all.) Broadcast IP Directed Broadcast Multicast Unicast. Which standard supported by some Aruba APs can enable a customer to accurately locate wireless client devices within a few meters? A. 802.11mc B. 802.11W C. 802.11k D. 802.11r . Your customer has asked you to assign a switch management role for a new user The IT Certification Guaranteed, The Easy Way! 25 customer requires the user role to only have Web Ul access to the System > Log page and only have access to the GET method for REST API for the /logs/event resource Which default AOS-CX user role meets these requirements? A. administrators B. auditors C. sysops D. operators . You need to have different routing-table requirements with Aruba CX 6300 VSF configuration Assuming the correct layer-2 VLAN already exists how would you create a new OSPF configuration for a separate routing table? A. Create a new OSPF area, and attach VRF name. B. Create a new OSPF process ID with vrf name. C. Attach a new OSFP process ID with a custom routing table D. Attach OSPF process ID in the VRF configuration. . What is an OSPF transit network? A. a network that uses tunnels to connect two areas B. a special network that connects two different areas C. a network on which a router discovers at least one neighbor D. a network that connects to a different routing protocol . A customer has a large number of food-producing machines * All machines are connected via Aruba CX6200 switches in VLANs 100.110. and 120 * Several external technicians are maintaining this special equipment What are the correct commands to ensure that no rogue DHCP server will impact the network? A. dhcp-snooping enable no dhcp-snooping option 82 dhcp-snooping vlan 100-120 vlan 100 name cornflakes vlan 110 name cornmill vlan 120 name packaging interface lag 1 no shutdown description Uplink-to-Core no routing vlan trunk native 1 vlan trunk allowed all lacp mode active dhcp snooping trust B. dhcp snooping enable no dhcp-snooping option 82 vlan 100 name cornflakes dhcp-snooping vlan 110 name cornmill dhcp-snooping vlan 120 name packaging dhcp-snooping interface lag 1 no shutdown description Uplink-to-Core no routing vlan trunk native 1 vlan trunk allowed all lacp mode active dhcp snooping trust C. dhcpv4-snooping all vlans no dhcpv4-snooping option 82 interface lag 1 no shutdown description Uplink-to-Core no routing vlan trunk native 1 vlan trunk allowed all lacp mode active dhcpv4-snooping trust D. dhcpv4-snooping no dhcpv4-snooping option 82 vlan 100 name cornflakes dhcpv4-snooping vlan 110 name cornmill dhcpv4-snooping vlan 120 name packaging dhcpv4-snooping interface lag 1 no shutdown description Uplink-to-Core no routing vlan trunk native 1 vlan trunk allowed all lacp mode active dhcpv4 snooping trust. You are doing tests in your lab and with the following equipment specifications: * AP1 has a radio that generates a 20 dBm signal * AP2 has a radio that generates a 8 dBm signal * AP1 has an antenna with a gain of 7 dBI. * AP2 has an antenna with a gain of 12 dBI. * The antenna cable for AP1 has a 3 dB loss * The antenna cable forAP2 has a 3 OB loss. What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for AP1? A. 2dBm B. 8 dBm C. 22 dBm D. 24 dBm . |
Report abuse